My New Keyless Entry

I bought a spare keyless entry to my minivan on eBay the otherday. As this is my first car that can be associated with the words remote and/or keyless, I was a bit new to the programming process. A brief internet search revealed the secrets to programing the magical fob. They are as follows...

How to program an additional remote for 2005 Toyota Sienna LE model.

1) Make sure that the key is not in the ignition, the doors are unlocked, and the driver's door is open.

2) Very quickly, without turning, insert and remove key from the ignition twice. (leave key out)

3) Close and open the driver door twice. (leave door in open position)

4) Again, insert key into the ignition and remove it. This time only once. (leave key out)

5) Close and open the driver door twice, then close the door.

6) Insert key into the ignition and leave it in the LOCK position.

A. Add mode:

A1) Turn the key to "ON" for 1 second, then turn back to "LOCK".

A2) Remove the key.

A3) You’ll hear the doors "LOCK" and 1 second later "UNLOCK" (just listen)

A4) On your remote, press the lock and unlock buttons simultaneously for 1 to 1½ seconds, then let go.

A5) On your remote, IMMEDIATELY press unlock by itself.

A6) You’ll get one of three responses:

R. Responses:

R1) You’ll hear the doors "LOCK", then "UNLOCK" once. The remote is accepted. If you want to program another remote, immediately proceed to step A4 with your second remote, otherwise open the driver’s door and the remote is registered.

R2) You’ll hear the doors "LOCK", then "UNLOCK" twice. Either you didn’t use the same remote in steps A4 and A5(not likely), or this remote was already registered.

The timing was off when you pressed the LOCK and UNLOCK buttons simultaneously and then UNLOCK by itself. Immediately press the two buttons together and the unlock by itself again. Keep trying until you get the locks to signal once that you have been successful. Then if you have another remote to program, quickly press its' buttons as before, until you hear the locks signal once. When you are finished, open and close the driver door to

lock in the programming.

R3) If no response, go back to step 1 near the beginning of these instructions.

I was truly amazed that this worked. Thank you world wide web! I wonder what other mystical things may be revealed by inserting and removing the van's key sprinkled with a random series of opening and closing doors?